Answer:
Start and End Date Validation in Inspector Mode and Encounter Edit Page
What is the new enhancement?
QTX now includes validation for the Start Date and End Date fields in both Inspector Mode and the Encounter Edit Page to ensure data accuracy and consistency.
Where does this validation apply?
The validation applies to:
-
Inspector Mode
-
Encounter Edit Page
What are the validation rules for Start Date and End Date?
The following rules apply in both modes:
-
Start Date cannot be greater than End Date
The Start Date must always be earlier than or equal to the End Date. -
Dates cannot be more than 120 days earlier than the current date
Both Start Date and End Date must fall within the last 120 days from today. -
Dates cannot be set in the future
Start Date and End Date must not be later than the current date.
Was this validation available before?
No. Previously, Start Date and End Date were not validated in either Inspector Mode or on the Encounter Edit Page.
Which QTX platforms are affected by this change?
This enhancement applies to:
-
Perform
-
Qualify
-
Launch
How does this enhancement help users?
This validation:
-
Prevents date-related errors that could impact reports or compliance
-
Ensures accurate data entry through automatic checks
-
Reduces manual verification and rework
-
Saves time and minimizes processing delays